Xinyu closed cooling tower, cooling tower manufacturers Jiujiang cooling towers of a successful design control leaching problem, bleaching water loss is less than 0.001%, which measures: 1, try to use low-speed fan, avoid too much air being brought into the mist . 2, with the water distributor compartment sleeves, collect sputtering droplets. 3, bottom basin is larger than the diameter of the housing design and equipped with PVC into the wind one hundred, effectively preventing the water splashing outside the tower. Low noise, use noise control principles: 1, to reduce the noise of the sound source. Fully enclosed self-cooled low-noise cooling tower motor, the motor is waterproof good performance, low noise, the cooling tower to meet the special requirements of the use conditions of the motor. 2, partition noise propagation paths. 3, the receiver protective measures. 1 cooling tower installation instructions, provided by the manufacturer base map, the first measurement of whether the correct embedded foundation, the foundation is level strong, otherwise, shall make the appropriate treatment or suspended installation. 2, the basic verification process intact, with pieces of iron and iron frame number, based on the complete installed iron frame, iron frame of each pedestal is not installed in the central embedded steel may make adjustments under the iron frame above located in the same horizontal plane as possible. 3, installation basin, basin tank combination is greater than the overall portfolio under the iron frame 15mm. 4, do the basin, tank leak-proof, the program should see the installation instructions. 5, the rear foot iron box under a corresponding adjustment base plate weld, but be sure to make fire safety. 6. The iron and iron frame installation drawing number to complete the installation on iron frame. 7, adjust the iron box so that each frame surface level, each vertical column iron frame combination length, width, height, diagonal line with a given size, and then tighten all the screws. 8. fillers and other accessories, and finally install the fan, motor, and carefully adjust until it reaches the design requirements.